E-MOTO EMVG3-SIL User's Guide download pdf (Page 45)

Adding an Additional Remote

1. Move the shade to full open.

2. Press and hold the UP button on a learned remote until the shade begins

to move, release.

3. Shade will move to the 75% position.

4. Tug the shade more than 2” to put into learn mode.

5. Press and hold UP button on the new remote until the shade begins to travel up.

6. New remote is learned.

1. Move the shade to full open.

2. Press and hold the UP button on a learned remote until the shade begins

to move, release.

3. Shade will move to the 75% position.

4. Tug the shade more than 2 inches to put into learn mode.

5. Press and hold DOWN button on the remote or channel to be deleted until

the shade begins to travel up.

6. Remote or channel is deleted.

Deleting A Remote

This procedure clears all original learned remote AND all hembar settings

1. Move the shade to full open.

2. Press and hold the up button on a learned remote until the shade starts moving,

do not release until shade reaches the 75% position and reverses, then release.

3. Shade will stop about 12 inches from the top.

4. Immediately tug shade more than 2 inches to delete all learned remotes and limits.

5. Shade will now be in learn mode for 60 seconds.

6. Learn a new remote by pressing and holding UP button on the remote until the

shade begins to move up. Lower limit will now be set to factory default 12 inches.

Full Master Reset Procedure

QMotion

Remote Settings

For shades produced prior to April 14th, 2013.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 66 67

No comments

E-MOTO EMVG3-SIL User's Guide Page 45