E-MOTO electric bicycle User Manual download pdf (Page 11)

NOTE: You may charge the battery while it is still mounted in the

frame of the bike. If doing so outside, ensure that the battery, charger,

and power cables are protected from the elements. Failure to do so

may result in electrocution, injury, or death.

Unlock the battery using the battery key, in the top keyhole of the

battery bracket. Next, tilt the battery toward you until it clears the

upper battery bracket. Finally, lift the battery up and out of the cradle.

Reinstallation is the reverse of removal. Take careful note to engage the

battery in the two notches at the front and rear of the cradle. Be sure

to lock the battery once it is replaced.

Start by unscrewing the round, chrome cap covering the charger •

port on the side of the battery case. Ensure that the power switch

on the battery is in the off position.

Insert the low-voltage plug from the battery charger into the round •

port on the battery, and hand-tighten the locking ring..

Connect the AC plug from the charger to a wall socket. Avoid using •

extension cords.

The light on the charger should now indicate a steady red light •

while charging. If the light remains green, the battery may already

be completely charged.

A full charge should take approximately 4-hours to complete, at •

which point the charger should indicate a steady green light.

When the charge is complete, rst, unplug the charger from the •

wall.

Then loosen the locking ring from the low voltage plug and remove •

the plug.

Hand tighten the cap over the charging port. The battery should be •

ready for use.

Removing the Battery:

Charging the Battery:

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

E-MOTO electric bicycle User Manual Page 11